PLFM_RADAR
Open-source, low-cost 10.5 GHz PLFM phased array RADAR system
Learn how to design an FPGA decimation filter for range bin reduction in PLFM RADAR. Compress 1024 bins to 64 using decimation, peak detection, or averaging for efficient radar processing.
IMU Integration with GY-85 for Pitch/Roll Correction in Target Coordinates: PLFM-RADAR Deep DiveLearn IMU integration with GY-85 for accurate pitch/roll correction in target coordinates within the PLFM-RADAR system. Enhance your georeferenced radar data.
Cross-Layer FPGA/STM32 Communication for Radar Control: AERIS-10 Architecture ExplainedExplore AERIS-10 cross-layer FPGA/STM32 communication for radar control. Discover how this architecture integrates FPGA signal processing with STM32 power sequencing and AGC feedback.
Radar Data Protocol Packet Structure and Frame Format in AERIS‑10 LFM RadarExplore the AERIS-10 LFM radar data protocol packet structure and frame format. Understand the fixed 17-byte header, variable IQ payload, and CRC-16 for high-throughput FPGA to PC USB streaming.
FPGA Software Replica for Offline Radar Data Processing and Replay: A Complete GuideExplore NawfalMotii79/PLFM_RADAR for a bit-accurate FPGA software replica of the AERIS-10 radar. Enable offline radar data processing and replay for algorithm development without hardware.
SPI Communication Setup for ADAR1000 and ADF4382 Devices in PLFM RADAR FirmwareLearn how to set up SPI communication for ADAR1000 and ADF4382 devices in PLFM RADAR firmware using STM32F7 and a layered SPI abstraction. Get efficient control for your radar system.
I2C Peripheral Addresses and Bus Configuration for DAC5578 and ADS7830 in PLFM RADAR FirmwareConfigure I2C addresses and bus settings for DAC5578 and ADS7830 in PLFM RADAR firmware. Understand peripheral addresses and bus configurations for efficient hardware integration.
USB CDC Communication with STM32 for GPS Data Streaming: Implementing a Virtual COM Port in PythonLearn USB CDC communication with STM32 for GPS data streaming. Implement a virtual COM port in Python to parse GPS frames independently of radar data. Explore the PLFM Radar project.
Range FFT and Doppler FFT Implementation in FPGA Signal Processing: A Complete Technical GuideLearn how to implement Range FFT and Doppler FFT in FPGA signal processing using a radix-2 DIT engine. Explore a complete technical guide for PLFM RADAR firmware.
Temperature Monitoring with ADS7830 ADC and Thermal Shutdown Thresholds in PLFM-RADARImplement robust temperature monitoring in your PLFM-RADAR system. Learn how the ADS7830 ADC and configurable thermal shutdown thresholds protect your hardware from overheating.
Emergency Stop Procedure for RF Power Amplifier Protection in PLFM-RADARLearn the emergency stop procedure for RF power amplifier protection in PLFM-RADAR. Discover how this routine prevents damage during critical faults like over-current or over-temperature.
ADAR1000 Phase Shifter Control for TX/RX Beamforming Patterns: Complete Implementation GuideMaster ADAR1000 phase shifter control for TX/RX beamforming patterns. This guide details SPI lookup table implementation for electronic steering, enabling flexible radar system design.
Have a question about this repo?
These articles cover the highlights, but your codebase questions are specific. Give your agent direct access to the source. Share this with your agent to get started:
curl -s "https://instagit.com/install.md" 
Maintain an open-source project? Get it listed too →